Siemens SINUMERIK 840D Diagnostics Manual page 505

10.04
105021
Definitions:
Remedy:
Program Continuation:
105022
Definitions:
Remedy:
Program Continuation:
105023
Definitions:
Remedy:
Program Continuation:
105024
Definitions:
Remedy:
Program Continuation:
105025
Definitions:
Remedy:
Program Continuation:
105026
Definitions:
Remedy:
Program Continuation:
105030
Definitions:
Remedy:
Program Continuation:
105031
Definitions:
Remedy:
Program Continuation:
105032
Definitions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Error during workpiece generation!
The workpiece could not be created.
--
Internal
Error during enabling!
The program could not be enabled.
--
Internal
File exists already!
The file cannot be copied to this directory, as a file with the same name is already here.
--
Internal
Check values! - At least 1 value lies outside the input limits!
An invalid value was entered in the cycle parameter image.
--
Internal
Please wait, the directory is being prepared!
The data required for the display of the directory is being determined.
--
Internal
Attention! The simulated program and edited program are not the same!
The program being executed is not identical to the program opened in the editor.
--
Internal
Please wait, renumbering is being carried out!
The part program's blocks are serially numbered.
--
Internal
Renumbering was aborted!
Renumbering of the part program was aborted.
Insufficient part program memory may be the cause of the error.
--
Internal
Renumbering finished!
Renumbering of the part program was completed without errors.
--
Internal
1 Alarms
1-505