Siemens SINUMERIK 840D Diagnostics Manual page 438

1 Alarms
Reactions:
Remedy:
Program Continuation:
61237
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61238
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61239
Definitions:
Reactions:
Remedy:
Program Continuation:
61240
Definitions:
Reactions:
Remedy:
Program Continuation:
1-438
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Simulate the subroutine first in ShopTurn or load it into the ShopTurn operating mode
"Machine auto".
Clear alarm with the RESET key. Restart part program
Channel %1 block %2: Retraction direction unknown. Manually retract tool!
%1 = Channel number
%2 = Block number, label
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Manually retract the tool from the retraction area defined in the program header and
restart the program.
Internal
Channel %1 block %2: Machining direction unknown!
%1 = Channel number
%2 = Block number, label
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Please contact the responsible Siemens regional office.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2: Tool change point lies in the retraction area!
The tool change point has to be far enough outside the retraction area so that when the
revolver is swivelled, no tool extends into the retraction area.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Specify another tool change point.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2: Wrong feed type
-
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check feed type.
Clear alarm with the RESET key. Restart part program
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04