Siemens SINUMERIK 840D Diagnostics Manual page 310

1 Alarms
Remedy:
Program Continuation:
18313
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
18314
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
18400
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
20000
Parameters:
1-310
Modify machine data.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 frame: illegal switchover of geometry axes
%1 = Channel number
%2 = Block number, label
It is not allowed to change the geometry axis assignment because the current frame con-
tains rotations.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Change NC program or set other mode with $MN_FRAME_GEOAX_CHANGE_MODE.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 frame: type conflict
%1 = Channel number
%2 = Block number, label
It is not possible to chain global frames and channel-specific frames. The alarm occurs if a
global frame is programmed with a channel axis name and no machine axis on this NCU
is assigned to the channel axis. Channel-specific frames cannot be programmed with
machine axis names if there is no corresponding channel axis on this NCU.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Modify part program.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 language change not possible:%3
%1 = Channel number
%2 = Block number, label
%3 = Cause
The selection of an external NC language is not possible due to the reason specified. The
following reasons are possible (see parameter 3):
1. Invalid machine data settings
2. Active transformation
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy the specified cause of the error before selecting the language.
Clear alarm with the RESET key. Restart part program
Channel %1 axis %2 reference cam not reached
%1 = Channel number
%2 = Axis name, spindle number
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04