Siemens SINUMERIK 840D Diagnostics Manual page 537

10.04
300004
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
300005
Definitions:
Reactions:
Remedy:
Program Continuation:
300006
Parameters:
Definitions:
Reactions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Axis %1 drive %2 wrong drive type %3 (FDD/MSD)
%1 = NC axis number
%2 = Drive number
%3 = Drive type code
A feed module is inserted in the rack location determined by the drive logic number, but in
the corresponding NCK-specific MD 13040 DRIVE_TYPE, a main spindle is defined (or
vice versa).
- NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department.
Select MD 13010 DRIVE_LOGIC_NR and search for the drive logic number that is indi-
cated in the alarm text. The location index number + 1 results in the associated rack loca-
tion number. The FDD/MSD module belonging to this location is determined by the
configuration in MD 13040 DRIVE_TYPE for the same location index.
FDD: identifier 1, MSD: identifier 2.
Switch control OFF - ON.
At least one module found on drive bus that has not been configured
At bus initialization at least one module was detected which did not have a drive number,
which amounts to one too many. Since all (!) modules on the drive bus must be correctly
initialized, all modules therefore also have to be accordingly specified in the machine
data.
- NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department. Check machine data; with
the NCK MD 13000 DRIVE_IS_ACTIVE a drive that is not yet in use but exists on the bus
can be declared as inactive. Inactive drives do not need installation and start-up or drive
data.
Switch control OFF - ON.
Module with drive number %1 has not been found on drive bus
%1 = Drive number
Not all of the drives stated in MD $MN_DRIVE_LOGIC_NR could be found on the drive
bus. You can find the associated module in the configuration display via the displayed
drive number.
- NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
1 Alarms
1-537