Siemens SINUMERIK 840D Diagnostics Manual page 513

10.04
Remedy:
Program Continuation:
111127
Definitions:
Reactions:
Remedy:
Program Continuation:
111200
Definitions:
Reactions:
Remedy:
Program Continuation:
111300
Definitions:
Reactions:
Remedy:
Program Continuation:
111301
Definitions:
Reactions:
Remedy:
Program Continuation:
111302
Definitions:
Reactions:
Remedy:
Program Continuation:
111303
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Inform the service department. Please contact the responsible Siemens regional office.
Internal
Absolute value plus not possible
The alarms 111110, 111115, 111126, 111127 and 111200 can occur at spindel start/stop.
The alarms 111110, 111115, 111126, 111127 and 111200 can occur at spindel start/stop.
- Alarm display.
Inform the service department. Please contact the responsible Siemens regional office.
Inform the service department. Please contact the responsible Siemens regional office.
Internal
Spindle positioning error
The alarms 111110, 111115, 111126, 111127 and 111200 can occur at spindel start/stop.
- Alarm display.
Inform the service department. Please contact the responsible Siemens regional office.
Internal
NC start key defective
Acknowledgement to the PLC user program, that the NC start key is defective, i.e., NC
and NO signal = 1.
- NC Start disable in this channel.
- Alarm display.
Replace the key.
Internal
NC stop key defective
Acknowledgement to the PLC user program, that the NC stop key is defective, i.e., NC
and NO signal = 1.
- NC Start disable in this channel.
- Alarm display.
Replace the key.
Internal
Spindle start key defective
Acknowledgement to the PLC user program, that the spindle start key is defective, i.e.,
NC and NO signal = 1.
- NC Start disable in this channel.
- Alarm display.
Replace the key.
Internal
Spindle stop key defective
Acknowledgement to the PLC user program, that the spindle stop key is defective, i.e.,
NC and NO signal = 1.
- NC Start disable in this channel.
- Alarm display.
Replace the key.
Internal
1 Alarms
1-513