Installing The Srx5400 Services Gateway Fan Tray; Maintaining The Air Filter On The Srx5400 Services Gateway - Juniper SRX5400 Hardware Manual

Installing the SRX5400 Services Gateway Fan Tray

To install the fan tray (see
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Grasp the fan tray handle and insert it straight into the chassis. Note the correct orientation by the this
side up label on the top surface of the fan tray.
3. Tighten the captive screws on the fan tray faceplate to secure it in the chassis.
Figure 96: Installing the Fan Tray

Maintaining the Air Filter on the SRX5400 Services Gateway

Purpose
For optimum cooling, verify the condition of the air filters.
Action
Regularly inspect the air filter. A dirty air filter restricts airflow in the unit, impeding the ventilation of
the chassis. The filter degrades over time. Periodically replace the filter in use, as well as spares. We
recommend that you replace the filter every six months. Discard used filters, do not attempt to clean
and reuse them.
Figure 96 on page 229):
229