Performing Initial Software Configuration Using J-Web - Juniper SRX5400 Hardware Manual

}
then {
}
}
}
}
}
18. Commit the configuration to activate it on the device.
[edit]
admin@# commit
19. Optionally, configure additional properties by adding the necessary configuration statements. Then
commit the changes to activate them on the device.
[edit]
admin@# commit
20. When you have finished configuring the device, exit configuration mode.
[edit]
admin@# exit
admin@host>

Performing Initial Software Configuration Using J-Web

IN THIS SECTION
Configuring Root Authentication and the Management Interface from the CLI | 215
Configuring Interfaces, Zones, and Policies with J-Web | 216
destination-address any;
application any;
permit;
214