Services Processing Card Srx5K-Spc-4-15-320 Specifications - Juniper SRX5400 Hardware Manual

Serial Number The serial number label is located as shown in
Location
Figure 33: Serial Number Label (IOC Shown, Other Cards Similar)
OK /F AIL

Services Processing Card SRX5K-SPC-4-15-320 Specifications

The SRX5K-SPC-4-15-320 Services Processing Card (SPC) contains four Services Processing Units (SPUs),
which provide the processing power to run integrated services such as firewall, IPsec, and IDP (see
Figure 34 on page 95). All traffic traversing the services gateway is passed to an SPU to have services
processing applied to it. Traffic is intelligently distributed by I/O cards (IOCs) to SPUs for services processing.
The services gateway must have at least one SPC installed. You can install additional SPCs to increase
services processing capacity.
You can install SPCs in any of the slots that are not reserved for Switch Control Boards (SCBs). If a slot is
not occupied by a card, you must install a blank panel to shield the empty slot and to allow cooling air to
circulate properly through the device.
If your services gateway contains a mix of SRX5K-SPC-4-15-320 SPCs and earlier SRX5K-SPC-2-10-40
SPCs, an SRX5K-SPC-4-15-320 SPC must occupy the lowest-numbered slot of any SPC in the chassis.
This configuration ensures that the center point (CP) function is performed by the faster and
higher-performance SPC type.
Figure 33 on page 94.
Serial number
ID label
AA567 8
94