Juniper SRX5400 Hardware Manual page 312

Firmware package is available on the USB flash drive and the firmware version matches the version of
Junos OS currently installed on the device. Use the show version command to identify the Junos OS
version. You can download the firmware from
The chassis cluster has only two redundancy groups (RG0 and RG1) configured.
This procedure includes the steps for replacing the Routing Engine on node 0 of a chassis cluster setup.
You can follow the same steps to replace the Routing Engine on node 1.
To replace a Routing Engine on node 0 of a chassis cluster using a USB flash drive:
1. Prepare to shut down node 0:
a. Perform a manual failover of the redundancy groups (RGs) from node 0 to node 1.
Fail over RG1:
root@node0> request chassis cluster failover redundancy-group 1 node 1
Fail over RG0:
root@node0> request chassis cluster failover redundancy-group 0 node 1
b. Verify that both RGs are active on node 1 after the failover:
root@node0> show chassis cluster status
{secondary:node0}
root@node0> show chassis cluster status
Monitor Failure codes:
CS Cold Sync monitoring
GR GRES monitoring
IF Interface monitoring
LB Loopback monitoring
NH Nexthop monitoring
SP SPU monitoring
CF Config Sync monitoring
Cluster ID: 1
Node Priority Status
Redundancy group: 0 , Failover count: 1
node0 129
node1 255
Redundancy group: 1 , Failover count: 1
node0 129
node1 255
https://support.juniper.net/support/downloads/
Preempt Manual
secondary no
primary no
secondary no
primary no
FL Fabric Connection monitoring
HW Hardware monitoring
IP IP monitoring
MB Mbuf monitoring
NP NPC monitoring
SM Schedule monitoring
RE Relinquish monitoring
Monitor-failures
no None
no None
no None
no None
315