Connecting Power To An Ac-Powered Srx5400 Services Gateway - Juniper SRX5400 Hardware Manual

Figure 87: Connecting the Grounding Cable
P E M 0
P E M 1
A IR
FI LT E R P E M 2
8. Dress the grounding cable and verify that it does not touch or block access to device components, and
that it does not drape where people could trip on it.

Connecting Power to an AC-Powered SRX5400 Services Gateway

WARNING:
to ensure proper operation, you must properly ground the services gateway chassis
before connecting power. See
for instructions.
CAUTION:
Damage to the device might occur.
NOTE: The SRX5400 Services Gateway and SRX5600 Services Gateway use the same power
supply model.
You connect AC power to the device by attaching power cords from the AC power sources to the AC
appliance inlets located on the power supplies. The power cords are not provided with the services gateway.
P E M 3
FA N
TR AY
To meet safety and electromagnetic interference (EMI) requirements and
"Grounding the SRX5400 Services Gateway" on page 199
Do not mix AC and DC power supplies within the same services gateway.
200