Moving The Mounting Brackets For Center-Mounting The Srx5400 Services Gateway - Juniper SRX5400 Hardware Manual
Services gateway
Hide thumbs
Also See for SRX5400:
- Hardware manual (406 pages) ,
- Reference (109 pages) ,
- Manual (102 pages)
Table of Contents
Advertisement
179
Figure 72: Installing the Mounting Hardware for an Open-Frame Rack
Moving the Mounting Brackets for Center-Mounting the SRX5400 Services
Gateway
Two removable mounting brackets are attached to the mounting holes closest to the front of the chassis.
You can move the pair of brackets to another position on the side of the chassis for center-mounting the
services gateway.
To move the mounting brackets from the front of the chassis toward the center of the chassis:
1. Remove the three screws at the top and center of the bracket.
2. Pull the top of the bracket slightly away from the chassis. The bottom of the bracket contains a tab
that inserts into a slot in the chassis.
3. Pull the bracket away from the chassis so that the tab is removed from the chassis slot.
4. Insert the bracket tab into the slot in the bottom center of the chassis.
5. Align the bracket with the two mounting holes located toward the top center of the chassis.
Advertisement
Table of Contents
Troubleshooting
