Maintaining Spcs On The Srx5400 Services Gateway - Juniper SRX5400 Hardware Manual

Slot 0 Online
PIC 0 Online
PIC 1 Online
PIC 2 Online
PIC 3 Online
Slot 1 Online
PIC 0 Online
PIC 1 Online
PIC 2 Online
PIC 3 Online
Slot 2 Online
PIC 0 Online
PIC 2 Online
19. Issue the show chassis cluster status command to make sure that the priority for all redundancy groups
is greater than zero.

Maintaining SPCs on the SRX5400 Services Gateway

Purpose
For optimum services gateway performance, verify the condition of the Services Processing Cards (SPCs).
The services gateway can have up to three FPCs (two SPCs) mounted horizontally in the card cage at the
front of the chassis. To maintain SPCs, perform the following procedures regularly.
Action
On a regular basis:
Check the LEDs on the craft interface corresponding to each SPC slot. The green LED labeled OK lights
steadily when an SPC is functioning normally.
Check the OK/FAIL LED on the faceplate of each SPC. If the SPC detects a failure, it sends an alarm
message to the Routing Engine.
Issue the CLI show chassis fpc command to check the status of installed SPCs. As shown in the sample
output, the value Online in the column labeled State indicates that the SPC is functioning normally:
user@host> show chassis fpc
Slot State
0 Online
1 Online
SRX5k SPC II
SPU Cp
SPU Flow
SPU Flow
SPU Flow
SRX5k SPC II
SPU Flow
SPU Flow
SPU Flow
SPU Flow
SRX5k IOC II
2x 40GE QSFP+
10x 10GE SFP+
(C) Total Interrupt
35 4
47 3
DRAM (MB) Heap
0 1024 13
0 1024 13
293
Buffer
25
25