Juniper SRX5400 Hardware Manual page 107

Hardware features
Software features
NOTE:
on:
If you configure any of the following invalid PIC combinations, the chassis will set PIC0 &
PIC1 combination online.
LEDs OK/FAIL LED, one bicolor:
10-Gigabit Ethernet LINK LED, one green per port:
40-Gigabit Ethernet LINK LED, one bicolor per port:
Line-rate throughput of up to 240 Gbps
Supports up to 32,000 queues per-slot
LAN-PHY mode at 10.3125 Gbps on a per-port basis
The ports are labeled as:
10-Gigabit Ethernet ports: 0/0 through 0/11 and 1/0 through 1/11
40-Gigabit Ethernet ports: 2/0 through 2/2 and 3/0 through 3/2
Optical diagnostics and related alarms
Two packet-forwarding engines, PFE0 and PFE1. PFE0 hosts PIC0 and PIC2. PFE1 hosts
PIC1 and PIC3.
Configurable LAN-PHY mode options per 10-Gigabit Ethernet port
Intelligent oversubscription services
At any one time you can have only one of the following PIC combinations powered
PIC0 & PIC1
PIC0 & PIC3
PIC2 & PIC1
PIC2 & PIC3
PIC0 & PIC2
PIC1 & PIC3
Solid green—MPC is functioning normally.
Blinking green—MPC is transitioning online or offline.
Red—MPC has failed.
Green—Link is up.
Off—Link is down or disabled.
Green—Link is up.
Amber—Link is disabled.
Off—Link is down.
108