Juniper SRX5400 Hardware Manual page 171

The shipping container measures 33.5 in. (85.1 cm) high, 28 in. (71.1 cm) wide, and 26 in. (66.0 cm) deep.
The total weight of the container containing the device and accessories can range from 153 lb (70 kg) to
351 lb (159.2 kg).
NOTE: The device is maximally protected inside the shipping crate. Do not unpack it until you
are ready to begin installation.
To unpack the device, follow these steps (see
1. Move the shipping crate to a staging area as close to the installation site as possible, where you have
enough room to remove the components from the chassis. While the chassis is bolted to the pallet,
you can use a forklift or pallet jack to move it.
2. Position the shipping crate with the arrows pointing up.
3. Open all the latches on the shipping crate.
4. Remove the front door of the shipping crate cover and set it aside.
5. Slide the remainder of the shipping crate cover off the pallet.
6. Remove the foam covering the top of the device.
7. Remove the accessory box and the SRX5400 Services Gateway Getting Started Guide.
8. Verify the parts received as described in
on page 174.
9. Remove the vapor corrosion inhibitor (VCI) packs attached to the pallet, being careful not to break the
VCI packs open.
10. To remove the brackets holding the chassis on the pallet, use a 1/2-in. socket wrench and a number 2
Phillips screwdriver to remove the bolts and screws from the brackets.
11. Store the brackets and bolts inside the accessory box.
12. Save the shipping crate cover, pallet, and packing materials in case you need to move or ship the device
at a later time.
Figure 70 on page 174):
"Verifying the SRX5400 Services Gateway Parts Received"
173