Srx5K-Mpc3-40G10G Specifications - Juniper SRX5400 Hardware Manual

Power requirement
Weight
LEDs
Serial number location

SRX5K-MPC3-40G10G Specifications

The SRX5K-MPC3-40G10G (IOC3) is an interface card that provides 10 Gigabit Ethernet and 40 Gigabit
Ethernet interfaces, with a Packet Forwarding Engine that provides a 240 Gbps line rate. This interface
card is supported on SRX5400, SRX5600, and SRX5800 Services Gateways. See
NOTE: These cards do not support plug-in Modular Interface Cards (MICs).
All ports on the interface card have dual-color LEDs for reporting link status.
The interface card also supports hot-pluggable optical modules.
Maximum of 570 W for the MPC with two MICs, including applicable transceivers.
NOTE:
To install and use SRX5K-MPCs in the SRX5600 and SRX5800 Services Gateways, you
must have high-capacity power supplies (either AC or DC) and high-capacity fan trays
installed in the services gateways. All models of SRX5400 Services Gateways already
include high-capacity supplies. If you do not have high-capacity power supplies and fan
trays installed, the services gateway will log an alarm condition when it recognizes the
SRX5K-MPCs.
On SRX5400 and SRX5600 Services Gateways with AC power supplies, we recommend
that you use high-line (220 V) input power to ensure that the devices have adequate
power to support SRX5K-MPCs.
Approximately 10 lb (4.5 kg) without MICs
OK/FAIL LED, one bicolor:
Green–The MPC is operating normally.
Blinking green–The MPC is transitioning to online or offline.
Red–The MPC has failed and is not operating normally.
Off–The MPC is powered down.
The serial number label is yellow and is located on the opposite side of the card.
Figure 39 on page 107.
106