Juniper SRX5400 Hardware Manual page 37

node0:
--------------------------------------------------------------------------
Offline initiated, use "show chassis fpc" to verify
{primary:node0}
user@host> show chassis fpc
node0:
--------------------------------------------------------------------------
Slot State
0 Online
1 Online
2 Offline
After pushing MPC online button:
user@host> show chassis fpc
Slot State
0 Online
1 Online
2 Offline
To bring an MPC back online using the Online/Offline buttons:
1. Press and hold the corresponding card's Online/Offline button on slot 1 on the craft interface. The
green OK/FAIL LED next to the button and the MPC's LED begins to blink. Hold until both the button's
LED and the MPC's LED are green and steady.
2. Issue the CLI show chassis fpc command to check the status of installed MPCs. As shown in the sample
output, the value Online in the column labeled State indicates that the MPC in slot 1 is functioning
normally:
Verify if the MPC is offline:
user@host> show chassis fpc
node0:
--------------------------------------------------------------------------
Temp CPU Utilization (%)
(C) Total Interrupt
35 7
46 4
---Offlined by cli command---
Temp CPU Utilization (%)
(C) Total Interrupt
34 5
46 3
---Offlined by button press---
Temp CPU Utilization (%)
Memory Utilization (%)
DRAM (MB) Heap
0 1024 13
0 1024 13
Memory Utilization (%)
DRAM (MB) Heap
0 1024 13
0 1024 13
Memory Utilization (%)
38
Buffer
25
25
Buffer
25
25