You configure the services gateway by issuing Junos OS command-line interface (CLI) commands, either
on a console device attached to the CONSOLE port on the Routing Engine, or over a telnet connection
to a network connected to the ETHERNET port on the Routing Engine.
Gather the following information before configuring the device:
Name the device will use on the network
Domain name the device will use
IP address and prefix length information for the Ethernet interface
IP address of a default router
IP address of a DNS server
Password for the root user
Initially Configuring the SRX5400 Services Gateway
This procedure connects the device to the network but does not enable it to forward traffic. For complete
information about enabling the device to forward traffic, including examples, see the appropriate Junos
OS configuration guides.
To configure the software:
1. Verify that the device is powered on.
2. Log in as the root user. There is no password.
3. Start the CLI.
root# cli
root@>
4. Enter configuration mode.
configure
[edit]
root@#
5. Set the root authentication password by entering either a cleartext password, an encrypted password,
or an SSH public key string (DSA or RSA).
209