Installing An Srx5400 Services Gateway Mic - Juniper SRX5400 Hardware Manual

Installing an SRX5400 Services Gateway MIC

To install a MIC:
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. If you have not already done so, power off the services gateway.
3. If the MIC uses fiber-optic cable, verify that a rubber safety cap is over each transceiver on the faceplate.
Install a cap if necessary.
4. On the MPC, pull the ejector knob that is adjacent to the MIC you are installing away from the MPC
faceplate. The ejector knob is located between the MIC and the rotational knob that retains the MPC
in the services gateway card cage. See
Figure 115: Installing a MIC
5. Align the rear of the MIC with the guides located at the corners of the MIC slot.
6. Slide the MIC into the MPC until it is firmly seated in the MPC. The ejector knob will automatically
move in towards the faceplate to lock the MIC in position as it seats.
If the MIC does not seat properly in the slot, pull the ejector knob all the way out and try again to seat
the MIC. The MIC will not seat properly unless the ejector knob is all the way when you start to insert
the MIC.
CAUTION:
components on the MIC.
7. After the MIC is seated in its slot, verify that the ejector knob is engaged by pushing it all the way in
toward the MPC faceplate.
Figure 115 on page
Slide the MIC straight into the slot to avoid damaging the
288.
288