Juniper SRX5400 Hardware Manual page 296

CAUTION:
An arc smaller than a few inches in diameter can damage the cable and cause
problems that are difficult to diagnose.
13. Connect the power cables to the chassis.
14. Power on the services gateway. The OK LED on the power supply faceplate should blink, then light
steadily.
15. Verify that the SPC is functioning correctly by issuing the show chassis fpc and show chassis fpc
pic-status commands.
Figure 117: Installing an SPC
Figure 118: Attaching a Cable to an SPC
Avoid bending a fiber-optic cable beyond its minimum bend radius.
Fiber-optic
cable connector
299