Juniper SRX5400 Hardware Manual page 324

root@node0# load override /var/tmp/node0-config-yyyy-mm-dd
root@node0# commit
root@node0# exit
5. Check the status of all the FPCs and PICs, and ensure that all the FPCs and PICs are online.
root@node0>show chassis fpc pic-status
6. Halt node 0 from the console:
root@node0> request system halt
7. Wait until a message appears on the console confirming that the services have stopped, and then
connect all the cables to node 0.
8. Boot up node 0 by pressing any key on the console.
9. Check the chassis cluster status on node 1:
root@node1> show chassis cluster status
Node 0 comes up and becomes the secondary node on both RG0 and RG1. Wait until the node 0
priority on RG1 changes to the configured value.
10. Verify that sessions are showing up on node 0, and that the number of sessions on node 0 is nearly
equal to the number of sessions on the primary node, node 1:
root@node1> show security monitoring
11. If the cluster is healthy, reset the cluster priorities:
root@node1> request chassis cluster failover reset redundancy-group 1
root@node1> request chassis cluster failover reset redundancy-group 0
327