I/O Card Srx5K-4Xge-Xfp Specifications - Juniper SRX5400 Hardware Manual

LEDs
Serial Number Location

I/O Card SRX5K-4XGE-XFP Specifications

The SRX5K-4XGE-XFP I/O card (IOC) supports four 10-Gigabit Ethernet ports (see
The IOC assembly combines packet forwarding and Ethernet interfaces on a single board, with four 10-Gbps
Packet Forwarding Engines. Each Packet Forwarding Engine consists of one I-chip for Layer 3 processing
and one Layer 2 network processor. The IOCs interface with the power supplies and Switch Control Boards
(SCBs).
You must install at least one IOC in the services gateway. The IOC can be of any of the available IOC or
Flex IOC types.
You can install IOCs in any of the slots that are not reserved for Switch Control Boards (SCBs). If a slot is
not occupied by a card, you must install a blank panel to shield the empty slot and to allow cooling air to
circulate properly through the services gateway.
OK/FAIL LED, one bicolor:
Steady green–The IOC is operating normally.
Red–The IOC has failed and is not operating normally.
Off–The IOC is powered down.
The serial number label is located as shown in
Figure 54: Serial Number Label (IOC Shown, Other Cards Similar)
OK /F AIL
Figure 54 on page 128.
Serial number
ID label
AA567 8
Figure 55 on page
128
129).