Installing The Mounting Hardware; Tools And Parts Required To Install The Srx5400 Services Gateway Mounting Hardware For A Rack Or Cabinet; Installing The Srx5400 Services Gateway Mounting Hardware For A Rack Or; Cabinet - Juniper SRX5400 Hardware Manual

CHAPTER 16

Installing the Mounting Hardware

Tools and Parts Required to Install the SRX5400 Services Gateway Mounting Hardware
for a Rack or Cabinet
Related
Documentation
Installing the SRX5400 Services Gateway Mounting Hardware for a Rack or Cabinet
Copyright © 2017, Juniper Networks, Inc.
Tools and Parts Required to Install the SRX5400 Services Gateway Mounting Hardware
for a Rack or Cabinet on page 137

Installing the SRX5400 Services Gateway Mounting Hardware for a Rack or

Cabinet on page 137

Moving the Mounting Brackets for Center-Mounting the SRX5400 Services

Gateway on page 140
To install the services gateway in a rack or cabinet, you need the following tools:
Phillips (+) screwdriver, number 2
Installing the SRX5400 Services Gateway Mounting Hardware for a Rack or Cabinet
on page 137
The services gateway can be installed in a four-post rack or cabinet or an open-frame
rack. Install the mounting hardware on the rack before installing the services gateway.
Install the mounting shelf, which is included in the shipping container, before installing
the services gateway. We recommend that you install the mounting shelf because the
weight of a fully loaded chassis can be up to 220 lb (100 kg).
Table 52 on page 137 specifies the holes in which you insert cage nuts and screws to install
the mounting hardware required. The hole distances are relative to one of the standard
U divisions on the rack. The bottom of all mounting shelves is at 0.02 in. above a U division.

Table 52: Four-Post Rack or Cabinet Mounting Hole Locations

Hole Distance Above U Division
3 1.51 in. (3.8 cm)
2 0.88 in. (2.2 cm)
0.86 U
0.50 U
137