Flex I/O Card (Srx5K-Fpc-Ioc) Specifications; Figure 39: Srx5K-Mpc3-100G10G Serial Number Label - Juniper SRX5800 Hardware Manual

SRX5800 Services Gateway Hardware Guide
Serial Number Location
Related
Documentation

Flex I/O Card (SRX5K-FPC-IOC) Specifications

64
The serial number label is located as shown in

Figure 39: SRX5K-MPC3-100G10G Serial Number Label

SRX5K-MPC3-40G10G Specifications on page 58
Cards Supported on SRX5400, SRX5600, and SRX5800 Services Gateways on page 35
The SRX5K-FPC-IOC Flex I/O card (Flex IOC)
slots that accept port modules that add Ethernet ports to your services gateway. A Flex
IOC with installed port modules functions in the same way as a regular IOC, but allows
greater flexibility in adding different types of Ethernet ports to your services gateway.
Each Flex IOC has a processor subsystem, which includes a 1.2-GHz CPU, a system
controller, 1 GB SDRAM, and two Packet Forwarding Engines with a maximum throughput
of 10 Gbps each.
You must install at least one IOC in the services gateway. The IOC can be of any of the
available IOC or Flex IOC types.
You can install Flex IOCs in any of the slots that are not reserved for Switch Control
Boards (SCBs). If a slot is not occupied by a card, you must install a blank panel to shield
the empty slot and to allow cooling air to circulate properly through the services gateway.
Figure 39 on page 64.
(Figure 2 on page 8) is an IOC with two
Copyright © 2015, Juniper Networks, Inc.