9
UTILITY OPERATION
9.4.7 Operating Target setting screen
The logical station No. for access to a multiple CPU system can be set on this screen.
POINT
Module information
Error history monitor
Item
Target module
1. To update the settings into the C Controller module, write the parameters on
the <<Online operation>> tab and power on and then off or reset the C
Controller system.
2. Set a programmable controller CPU as the Target CPU.
Figure 9.96 Target setting screen
Table9.88 Explanation of Target setting screen
Other station monitor
Select the module to be set.
(Initial value: "1 slot", Setting range: "1 slot" to "4 slot")
Online operation
Parameter setting
Description
9.4 MELSECNET/H Utility
9.4.7 Operating Target setting screen
Target setting
(To next page)
9
- 129
9
10
11
12
13
14
15
16