Mitsubishi MELSEC-Q Series User Manual page 162

5
SETTINGS AND PROCEDURES BEFORE OPERATION
(To 1) on previous page)
(To 1) on previous page)
5
- 14 5.3 Settings and Procedures before Operation
2)
Move the RUN/STOP/MODE switch of the C Controller
module from STOP to RUN, and check that the C
Controller module is in the RUN status (the RUN LED is
lit).
Check the operation status (e.g. errors) in the system
information of the C Controller setting utility.
On the CC-Link utility, check the operation status (e.g.
errors). (Module information, Other station monitor, Test,
etc.)
On the Device monitor utility, make sure that access can
be made to its own station or other stations.
No
Is there no error?
Create and debug a user program using Tornado, and
register it to the C Controller module.
Operation
3)
Write the set parameters from the <<Online operation>>
tab of the CC-Link utility to the C Controller module.
Set the switches of all CPU modules from STOP to RUN.
Reset CPU No.1.
(Reset operation makes the written parameters
effective.)
Check that all CPU modules are in the RUN status (the
RUN LED is lit).
Check the operation status (e.g. errors) in the system
information of the C Controller setting utility.
On the CC-Link utility, check the operation status (e.g.
errors). (Module information, Other station monitor, Test,
etc.)
On the Device monitor utility, make sure that access can
be made to its own station or other stations.
No
Is there no error?
Create and debug a user program using Tornado, and
register it to the C Controller module.
Operation
* 1 To write the parameters, connect the utility to the C Controller module with the write authority.
( Section 5.11, Section 9.1.3)
Figure 5.12 Flowchart for CC-Link system configuration (Continued)
Yes
*1
Yes
Section 5.4 (2)
Section 9.3.2, 9.3.3,
9.3.7
Section 9.5
Chapter 10
Section 9.3.4
Section 5.4 (2)
Section 5.4 (2) and
user's manual of the
CPU module used
Section 13.6
Section 13.6 and user's
manual of the CPU
module used
Section 5.4 (1)
Section 5.4 (1) and
user's manual of the
CPU module used
Section 9.3.2, 9.3.3,
9.3.7
Section 9.5
Chapter 10