Mitsubishi MELSEC-Q Series User Manual page 246

8
INSTALLING AND UNINSTALLING SW[]PVC-CCPU
(From previous page)
(To next page)
8
- 4 8.2 Installation
5) The screen on the left shows that "Setup.exe" was
detected.
Click the button to start installation.
Finish
If "Setup.exe" was not found, click the
and change it to the location where "Setup.exe" exists.
6) When the left message has appeared, SW PVC-CCPU
has already been installed.
For overwriting, click
7) As the left screen appears, make sure that all programs
have been closed, and click
If any of programs is running, click
installation, and close all of the running programs.
After that, execute installation again.
8) When the left screen has appeared, click the
button.
9) When SW PVC-CCPU has already been installed, the
left screen appears.
To overwrite it into the folder displayed on the screen,
click to start installation and proceed to Step 11).
Yes
To install it into another folder, click
installation, uninstall the SW PVC-CCPU, and reinstall
it.
Browse...
to start installation.
OK
.
OK
to stop the
Cancel
to cancel the
No
button
Next>