Mitsubishi MELSEC-Q Series User Manual page 278

9
UTILITY OPERATION
(2) Module monitor screen
Module information Event history
Item
*1
Slot No.
Start I/O No.
Control CPU
9
- 28 9.2 C Controller Setting Utility
9.2.5 Operating Module monitor screen
The input (X), output (Y) and buffer memory statuses of the module installed to the
selected slot are monitored on this tab.
Also the forced output of the output (Y) and forced write to the buffer memory can be
executed.
1)
Table9.13 Explanation of Module monitor screen
Module monitor
SRAM monitor
Set the slot No. to be monitored.
In a multiple CPU system configuration, setting slot No. of a CPU module
installed allows monitoring of the CPU shared memory.
"CPU" can be set only in a multiple CPU system configuration.
(Initial value: 0, Setting range: "CPU", 0 to 63)
Displays the start I/O No. of the module installed to the slot set in "Slot
No.".
Displays the CPU No. that controls the module installed to the slot set in
"Slot No.".
Displays " " (blank) if the slot where a CPU module is installed or to which
"CPU (Empty)" is set in I/O assignment is specified in "Slot No."
(When the C Controller module, to which the C Controller setting utility is
connected, is a control CPU, "*" is displayed on the right side of the CPU
No. indication.)
* 1 The slot No. cannot be changed during monitoring.
Change it after stopping monitoring.
2)
Figure 9.29 Module monitor screen
Online operation
Description
3)
Reference
section
(To next page)