Mitsubishi MELSEC-Q Series User Manual page 280

9
UTILITY OPERATION
Module information Event history
Item
Buffer memory offset
CPU common memory
3) Buffer memory area
Format
9
- 30 9.2 C Controller Setting Utility
9.2.5 Operating Module monitor screen
Table9.13 Explanation of Module monitor screen (Continued)
Module monitor
SRAM monitor
Specify the buffer memory offset address of the intelligent function
module to be monitored.
This address can only be set for the intelligent function module.
This area display is switched to "CPU common memory offset" when the
slot to which a CPU module is installed is specified in "Slot No."
(Initial value: 0, Setting range: 0 or more)
Specify the address of the CPU shared memory to be monitored.
This area display is switched to "Buffer memory offset" when the slot to
which any other than CPU modules is installed is specified in "Slot No."
(Initial value: 0, Setting range: 0 to FFF
Displays the buffer memory status of the slot specified in the slot No.
Double-clicking this displays the "Data Change" screen. Entering a value
on the "Data Change" screen executes forced write.
Select the format ("DEC.", "HEX.") of displaying the input (X) and output
(Y) status in words and the buffer memory status.
The selected format is also reflected on the numerical input format used
for the forced word output of the output (Y) status or the forced write to the
buffer memory.
(Initial value: "HEX.", Setting range: "DEC." or "HEX.")
* 4 Refer to the following for the buffer memory address of the intelligent function module.
Manual of corresponding module
* 5 Refer to the following for the CPU shared memory addresses.
Section 14.3.1
Online operation
Description
*4
)
H
Reference
section
*5
*3