Network Settings For 1:1 Connection - Mitsubishi MELSEC-Q Series User Manual

5
SETTINGS AND PROCEDURES BEFORE OPERATION

5.6 Network Settings for 1:1 Connection

Connect the development environment (personal computer) to the C Controller module on
a one-to-one (1:1) basis by a crossing cable.
After that, set the C Controller module using the C Controller setting utility on the
development environment (personal computer).
This section explains the network settings on the personal computer for 1:1 connection of
the C Controller module and development environment (personal computer).
(1) System configuration for 1:1 connection
(2) Network settings of development environment (personal computer)
5
- 24 5.6 Network Settings for 1:1 Connection
C Controller module
Figure 5.23 System configuration for 1:1 connection
(a) Network settings of development environment (personal computer)
Set the same network address as that of the C Controller module.
Network part
192.168.3.
IP address
255.255.255.
Subnet mask
C Controller module
Figure 5.24 Network settings of development environment (PC)
Crossing cable
Set the same value.
Host part Network part
3 192.168.3.
255.255.255.
0
Development environment
(personal computer)
Development environment
(personal computer)
Set different values.
Host part
1
0