Mitsubishi MELSEC-Q Series User Manual page 423

10
FUNCTIONS AND PROGRAMMING
(2) IP address setting of C Controller module
Remark
The IP address of the C Controller module must be specified for Tornado to debug the
user program by connecting the development environment (personal computer) and
C Controller module via Ethernet.
1) Start Tornado.
2) Select [Tools] [Target Server]
"Configure Target Severs" dialog box.
3) Select "Back End" in the "Target Server Properties" pull-down menu.
4) Select "wdbrpc" from the "Available Back Ends" list.
5) In "Target Name/IP Address", set the IP address of the C Controller module to
be connected.
As the IP address of the C Controller module, set the detailed setting screen
"IP address" value on the <<Online operation>> tab of the C Controller setting
utility.
4)
Figure 10.7 IP address setting of the C Controller module
Refer to the Tornado manual for other debugging methods.
10.2 Programming Using Bus Interface Functions
[Configure] from the menu bar to open the
10.2.6 Precautions for program debugging
9
10
11
12
3)
13
5)
14
15
16
10
- 22