Mitsubishi MELSEC-Q Series User Manual page 425

10
FUNCTIONS AND PROGRAMMING
(4) Shell display setting
Remark
The following setting must be made to display output information (such as printf) from
each task of the C Controller module on Shell.
When the following setting is not made, only the output information on the Shell task is
displayed.
1) Start Tornado.
2) Select [Tools] [Target Server]
"Configure Target Severs" dialog box.
3) Select "Console and Redirection" in the "Target Server Properties" pull-down
menu.
4) Select the "Redirect Target IO" check box.
4)
Refer to the Tornado manual for other debugging methods.
10.2 Programming Using Bus Interface Functions
[Configure] from the menu bar to open the
Figure 10.10 Shell display setting
10.2.6 Precautions for program debugging
9
10
11
12
3)
13
14
15
16
10
- 24