Mitsubishi MELSEC-Q Series User Manual page 376

9
UTILITY OPERATION
Item
Identical point assignment
Equal assignment
M station -> L station equal
assignment
Start station
End station
Start No.
Total points
assigned
M station <- L station equal
assignment
button
OK
button
Cancel
9
- 126 9.4 MELSECNET/H Utility
9.4.6 Operating Parameter setting screen
(b) When "LX/LY setting (1)" or "LX/LY setting (2)" is set for "Switch screens"
on "Parameter setting" screen
Figure 9.94 Equal assignment screen (for LX/LY setting (1))
Table9.85 Explanation of Equal assignment screen (for LX/LY setting (1)/(2))
Equally assigns the input points to the link devices of each station. (Unit: 16 points)
Note that no points are assigned to the station set as an I/O master station.
(Initial value: "(Blank)", Setting range: 16 or more)
Equally divides the input points and assigns them to the link devices of each station.
Set the method of making equal assignment to LY(1) or LY(2).
Set the first of the stations to which equal assignment will be performed.
(Initial value: "(Blank)", Setting range: 1 to ("Total stations"
Set the last of the stations to which equal assignment will be performed.
(Initial value: "(Blank)", Setting range: ("Start station" setting) to ("Total stations"
setting))
Set the start No. of the link device to be equally assigned.
(Initial value: "(Blank)", Setting range:
Set the total points of the link devices to be equally assigned.
(Initial value: "(Blank)", Setting range:
Set the method for equal assignment to LX(1) or LX(2).
Set each setting item as in "M station -> L station equal assignment".
Executes equal assignment according to the settings, and closes the "Equal
assignment" screen.
Closes the "Equal assignment" screen without executing equal assignment.
* 1 "Total stations" is set in "Network range assignment" on the "Parameter setting" screen
( This section (1)).
Description
*1
setting))
This section (1)(a))
This section (1)(a))
*1