Mitsubishi MELSEC-Q Series User Manual page 522

14
COMMUNICATIONS BETWEEN CPU MODULES
(4) Sequence program instruction (S(P).GINT) used for event notification
Setting Internal device
data (System, user)
Bit
(n1)
(n2)
[Setting data]
[Usable devices]
14
- 5 14.2 Event Notification
The following indicates the programmable controller CPU-dedicated instruction used
for event notification.
Table14.4 Devices applicable to S(P).GINT instruction
Link direct device
File
register
R, ZR
Word Bit
*1*2
*2
* 1 In the case of the High Performance model QCPU, indexing is available.
* 2 In the case of the Basic model QCPU, indexing is available.
[Instruction symbol]
SP.GINT
S.GINT
Setting data
Start I/O No. of target CPU 16
The following value is actually specified.
(n1)
CPU No. 1: 3E0
4: 3E3
H
Interrupt pointer No.
(n2)
(0 to 15)
The following devices are available for dedicated instructions.
Internal device
Bit
M, L, B
* 1 Digit specification of bit device can be used for word data.
Digits of a bit device can be specified with
For example, 16 points from M0 to M15 are specified with
* 2 Available devices are given in the Constant field in each section.
Applicable devices
Intelligent
function module
J \
U \G
Word
[Execution condition]
Command
Command
Figure 14.3 S(P).GINT instruction
Table14.5 Setting data in S(P).GINT instruction
Settings
, CPU No. 2: 3E1 , CPU No. 3: 3E2
H H
Table14.6 Usable Devices
*1
Word
D, W, @
Number of digits
Index register Constant
Zn
:Can be set,
SP.GINT (n1)
S.GINT (n1)
, CPU No.
H
File register Constant*2
R, ZR
Head No. of bit device
.
K4M0
Others
K, H
: Cannot be set
(n2)
(n2)
Data type
BIN 16 bits
BIN 16 bits
K, H
.