Setting The Parameters On Gx Developer; Parameter Setting Screen - Mitsubishi M800S Series Connection And Set Up Manual

Hide thumbs Also See for M800S Series:

Table of Contents

M800S/M80/E80 Series Connection and Setup Manual

20 Sequence Program Writing

20.5 Setting the Parameters on GX Developer

There are two methods of ladder programming; independent program method and multi-program method,

which makes differences in parameter settings. An incorrect parameter setting in the ladder programming may

cause a write error.

For details of the parameter settings, refer to the "PLC Development Manual".

(1) Displaying the project data list and parameter setting screen

Display the "Project data list" window with the following operations. Double-click on "PLC parameter" to open the

parameter setting screen. The same operation can be carried out by designating the data type "Parameter" and the

data name "PLC parameter" from the tool bar.

[View] -> [Project data list] and then double-click "PLC parameter".

(2) Displaying the parameter setting screen

Perform the following operations to display the parameter setting screen. The characters of tab in "red" show that

the settings are the initial values.

Project data list window

PLC parameter

IB-1501269-J

M80 series E80 series M80w series