Setting Parameters Required For Communications; Parameter List - Mitsubishi Melsec-L Series User Manual

7.1

Setting Parameters Required for Communications

This section describes how to set parameters to communicate between the E71 and connected devices.
7.1.1

Parameter list

The following table lists parameters set through a programming tool.
Item
Basic setting
Operation Setting
Initial Setting
Open Setting
Router Relay Parameter
Network
Parameter
Station No. <-> IP Information
FTP Parameters
E-mail Setting
Interrupt Settings
Routing Parameters
Valid Module During Other Station
Access
Remote
Remote Password
Password
Network Type
Start I/O No.
Network No.
Configure settings to use the E71 as a network
module.
Group No.
Station No.
Mode
Configure the settings, such as an IP address, to
connect the E71 to Ethernet.
Set a data communication timer value.
Configure connection settings.
Configure settings to communicate with connected
devices on Ethernet via a router and a gateway.
Configure settings (e.g. network number and
station number) to communicate with other network
modules.
Configure the settings of the file transfer (FTP)
function.
Configure the settings of the e-mail function and the
automatic notification function.
Set the control number (SI) on the E71 side to
request an interrupt to the CPU module.
Set the communication path to communicate with a
station having a different network number.
Select a relay module when an access request with
no network number specified is issued from
another station.
Select the connection protected by a remote
password.
CHAPTER 7 COMMUNICATION PROCEDURE
Description Reference
Page 64, Section 7.1.2
Page 65, Section 7.1.3
Page 246, Appendix 3.1
Page 67, Section 7.1.4,
Parameter setting of each
function
MELSEC-Q/L Ethernet
Interface Module User's
Manual (Application)
Page 98, Section 10.5.1
MELSEC-Q/L Ethernet
Interface Module User's
Manual (Application)
-
Page 140, Section 12.3
63
7