Mitsubishi MELSEC-Q Series User Manual page 321

9
UTILITY OPERATION
Other station monitor
Module information
Item
Read parameter
button
Read
Write parameter
button
Write
Verify parameter
button
Verify
Remark
Table9.48 Explanation of Online operation screen
Online operation
Reads the CC-Link parameters from the C Controller module.
Writes the set CC-Link parameters to the C Controller module.
The written parameters become effective when the C Controller module is powered off
and then on or is reset.
This button can be used only when "Write authority" was set at the time of connection
target setting ( Section 9.1.3).
This button cannot be used without "Write authority" (
Compares the CC-Link parameters of the C Controller module with those of the CC-Link
utility.
The result is displayed in the message box.
* 1 When parameter writing is needed with no "Write authority" setting, make the connection target
setting again and check the "Write authority" box.
Reading/writing/verification can be performed only when the C Controller module
is connected online.
Parameter setting Target setting
Description
9.3 CC-Link utility
9.3.4 Operating Online operation screen
Test
*1
Section 9.1.3).
9
- 71
9
10
11
12
13
14
15
16