3.3
Procedures Before Operation
This section describes the procedures before operation.
1.
Check of multiple input module specifications
Check the multiple input module specifications. (Page 328 Specifications)
2.
Installation of multiple input module
Install a multiple input module to a CPU module. For details, refer to the following.
MELSEC iQ-F FX5U User's Manual (Hardware)
MELSEC iQ-F FX5UC User's Manual (Hardware)
3.
Wiring
Perform wiring of external devices to a multiple input module.
4.
Adding a module
Add a multiple input module to a module configuration by using GX Works3.
When adding a new multiple input module, if selecting the module whose module model name has "(FX2N)"
at the end, it can be used as FX2N allocation mode.
• FX5-8AD: Normal mode
• FX5-8AD(FX2N): FX2N allocation mode
5.
Parameter settings
Set parameters of the multiple input module by using GX Works3. (Page 396 Parameter Setting)
6.
Offset/gain setting
When setting the user range, perform the offset/gain setting.
7.
Programming
Create a program.
3.4
Functions
This section describes the functions of a multiple input module and the setting procedures for those functions.
For details on the buffer memory areas, refer to the following.
Page 422 Buffer Memory Areas
• This sectionr describes buffer memory addresses for CH1. For details on the buffer memory addresses after
CH2, refer to the following.
Page 422 List of buffer memory areas
• Numerical values corresponding to the channel where an error has occurred and the error description fit in
the and of an error code and alarm code described in this section. For details on the numerical values,
refer to the following.
Page 414 List of error codes
Page 417 List of alarm codes
3 FX5-8AD
336
3.3 Procedures Before Operation