Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 170

CH1 Loading interrupt enable/disable setting
Set whether to enable or disable the logging read function.
For details on the logging function, refer to the following.
Page 59 Logging function
Setting value
0
1
• Setting a value other than the above causes a read interrupt enable/disable setting error (error code: 1D8H). Logging
cannot be performed.
• When set to Enable (0), an interrupt is generated and sent to the CPU module by setting a read pointer each time an
amount equivalent to the logging read points setting value is logged.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Logging loading enable/disable setting
CH Logging loading enable/disable setting (in
FX3 allocation mode function)
■Enabling the setting
Turn offonoff 'Operating condition setting request' (Un\G70, b9) to enable the setting.
■Default value
The default value is Disable (1) for all the channels.
CH1 Logging read points setting value
An interrupt is generated to the CPU module each time the data equal to the set data points is logged.
For details on the logging function, refer to the following.
Page 59 Logging function
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Logging load points setting value
CH Logging load points setting value (in FX3
allocation mode function)
■Setting range
The possible setting range is from 10 to 10000.
Setting a value out of the range causes a logging load points setting value range error (error code: 1D9H). Logging cannot
be performed.
■Enabling the setting
Turn offonoff 'Operating condition setting request' (Un\G70, b9) to enable the setting.
■Default value
The default value is 1000 for all channels.
APPX
168
Appendix 4 Buffer Memory Areas
Setting content
Enable
Disable
CH1 CH2
544 744
9271 9272
CH1 CH2
545 745
9281 9282
CH3 CH4
944 1144
9273 9274
CH3 CH4
945 1145
9283 9284