2.7
Parameter Settings
Set the parameters of each channel.
Setting parameters here eliminates the need to program them.
Parameter setting procedure
1.
Add the analog output module to GX Works3.
[Navigation window] [Parameter] [Module Information] Right-click [Add New Module]
2.
There are two parameter setting types: module parameter and module extension parameter settings, both of which can
be set after selecting them from the tree on the following window.
[Navigation window] [Parameter] [Module information] [Target Module]
3.
Using GX Works3, write the settings to the CPU module.
[Online] [Write to PLC]
4.
The settings are reflected by resetting the CPU module or turning the power supply offon.
When adding a new analog output module, if selecting the module whose module model name has "(FX3)" at
the end, it can be used as FX3 allocation mode.
• FX5-4DA: Normal mode
• FX5-4DA(FX3): FX3 allocation mode
For details on the FX3 allocation mode function, refer to Page 237 FX3 allocation mode function
This section describes the case in a normal mode.
2 FX5-4DA
244
2.7 Parameter Settings