Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 218

• For the previous value
While the wave output is at a pause, the analog output value generated when the pause occurred is held.
CPU module status
CH1 D/A conversion
enable/disable setting (Un\G500)
CH1 Output enable/disable flag
(Un\G70, b1)
CH1 Wave output start/stop
request (Un\G462)
CH1 Wave output status monitor
(Un\G401)
Wave data
Output value as per the setting of CH1
Output setting during wave output stop (Un\G524)
• For the setting value
While the wave output is at a pause, the HOLD setting value is output.
CPU module status
CH1 D/A conversion
enable/disable setting (Un\G500)
CH1 Output enable/disable flag
(Un\G70, b1)
CH1 Wave output start/stop
request (Un\G462)
CH1 Wave output status monitor
(Un\G401)
Wave data
Output value as per the setting of CH1
Output setting during wave output stop (Un\G524)
Output value set with CH1 HOLD setting value (Un\G596)
2 FX5-4DA
216
2.4 Functions
OFF
Wave output
Wave output stop request (0)
start request (1)
Wave output stopped (0)
Analog output
Offset value
OFF
Wave output
Wave output stop request (0)
start request (1)
Wave output stopped (0)
Analog output
Offset value
RUN
D/A conversion enable (0)
ON
Wave output
pause request (2)
Wave output
Wave output paused (2)
in progress (1)
In the case of the previous
value, the analog output
value generated when the
pause occurred is held.
RUN
D/A conversion enable (0)
ON
Wave output
pause request (2)
Wave output
Wave output paused (2)
in progress (1)
In the case of the setting
value, the HOLD setting
value is output.
Wave output start request (1)
Wave output stopped (0)
Wave output
in progress
(1)
Wave output start request (1)
Wave output stopped (0)
Wave output
in progress
(1)