Chapter 4 Procedures Before Operation; Startup Of High Speed Data Communication Module; Procedure To Operate By Installing Configuration Tool - Mitsubishi Electric MELSEC iQ-R Series User Manual

4
PROCEDURES BEFORE OPERATION
This chapter shows the procedures before operation for using a high speed data communication module.
4.1
Startup of High Speed Data Communication
Module

Procedure to operate by installing Configuration Tool

This section shows the procedure for using a high speed data communication module by installing Configuration Tool.
: No operation required
Step High speed data
communication module
1 Mount a high speed data
communication module on the base
*2
unit.
2 
3 Connect the high speed data communication module to a configuration personal
computer on a 1:1 basis. (Page 55 System configuration for the initial setup,
maintenance, and inspection)
4 Turn the power of a CPU module ON.
(The high speed data communication
module's RUN LED turns ON.)
5 Insert an SD memory card in the high
speed data communication module.
(Page 50 SD Memory Card)
6 
7
8
9
10
11
12 Turn the power of the CPU module
OFF.
13 Connect the high speed data communication module, configuration personal computer, and development personal
computer to the network according to the network settings set in Configuration Tool.
14 Turn the power of the CPU module
ON.
15 Check the operation.

16
17
18
*1 Perform the self-diagnostic test as necessary. (MELSEC iQ-R High Speed Data Communication Module User's Manual
(Application))
*2 Do not use an electric screwdriver to attach and remove module fixing screws.
*3 For the operation methods of Configuration Tool, refer to the following:
MELSEC iQ-R High Speed Data Communication Module User's Manual (Application)
*4 For details on the user program, refer to the following:
Configuration personal
*1
computer

Install Configuration Tool. (Page
62 INSTALLATION AND
UNINSTALLATION)

Start Configuration Tool. (Page 38
Offline startup)
Select "Direct connection" in the
*3
"Transfer setup" screen.
Format the SD memory card as
*3
necessary.
Set the common setting.
*3
Set the label setting.
Write the settings to a high speed data
*3
communication module.



Development personal
computer

*3
Copy High Speed Data
Communication Library.
Create a user program.



Copy a user program execution
file to the host computer.

4 PROCEDURES BEFORE OPERATION

4.1 Startup of High Speed Data Communication Module

Host computer

*4
*4
Connect a host computer to the
high speed data communication
module.

Execute the user program.
4
*4
35