Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 304

Interrupt factor reset request [n]
An interrupt factor reset request is sent.
Setting value
0
1
When Reset request (1) is set to 'Interrupt factor reset request [n]' (Un\G156 to Un\G171) corresponding to the interrupt factor,
the interrupt factor corresponding to the specified interrupt is reset. After that, 'Interrupt factor detection flag [n]' (Un\G4 to
Un\G19) turns to 'No interrupt factor' (0). When the set value is two or larger, the setting is regarded as Reset request (1).
Interrupt factors can also be reset by turning on and off 'Operating condition setting request' (Un\G70, b9).
"n" indicates an interrupt setting number. (n = 1 to 16)
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Interrupt factor reset request [n]
Interrupt factor reset request [n]
(in FX3 allocation mode function)
■Default value
The default value is No reset request (0) for buffer memory areas.
Step action wave output request
Set whether to execute the step action wave output for all the analog output channels in a batch.
Step action wave output request
OFF
ON
The setting for this area is enabled only in the wave output mode. In other modes, changing the setting value is ignored.
When the setting value is changed from OFF (0) to ON (1), the wave output status in all the channels, where the D/A
conversion is enabled, is changed to During wave output step action and the wave output step action function is enabled.
When the setting value is changed from ON (1) to OFF (0), the wave output status is changed to During wave output stop and
the wave output step action ends.
When a value out of the setting range is set, a step action wave output request range error (error code: 1D80H) occurs and
the wave output status is not changed.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Step action wave output request
Step action wave output request (in FX3
allocation mode function)
■Default value
The default value is OFF (0).
APPX
302
Appendix 8 Buffer Memory Areas
1 2 3 4 5
156 157 158 159 160
4041 4042 4043 4044 4045
CH1
188
9000
Setting content
No reset request
Reset request
6 7 8 9 10
161 162 163 164 165
4046 4047 4048 4049 4050
Setting value
0
1
CH2 CH3
11 12 13 14 15
166 167 168 169 170
4051 4052 4053 4054 4055
CH4
16
171
4056