Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 168

CH1 Level trigger condition setting
Set the condition for the occurrence of a hold trigger when using the level trigger in the logging function.
To use the level trigger, perform level trigger condition setting to one of Level trigger (Condition: Rise) (1), Level trigger
(Condition: Fall) (2), or Level trigger (Condition: Rise and fall) (3).
For details on the logging function, refer to the following.
Page 59 Logging function
Setting value
0
1
2
3
Setting a value other than the above causes a level trigger condition setting range error (error code: 1D5H).
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Level trigger condition setting
CH Level trigger condition setting (In FX3
allocation mode function)
■Enabling the setting
Turn offonoff 'Operating condition setting request' (Un\G70, b9) to enable the setting.
■Default value
The default value is Disable (0) for all the channels.
CH1 Trigger data
Set a buffer memory address to be monitored using a level trigger.
Set the buffer memory address where the target data for monitoring is stored.
For details on the logging function, refer to the following.
Page 59 Logging function
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
CH Trigger data
CH Trigger data (In FX3 allocation mode
function)
■Setting range
The possible setting range is from 0 to 9999.
Setting a value out of the range causes a trigger data setting range error (error code: 1D6H). Logging cannot be performed.
■Enabling the setting
Turn offonoff 'Operating condition setting request' (Un\G70, b9) to enable the setting.
APPX
166
Appendix 4 Buffer Memory Areas
Setting content
Disable
Level trigger (Condition: Rise)
Level trigger (Condition: Fall)
Level trigger (Condition: Rise and Fall)
CH1 CH2
540 740
9211 9212
CH1 CH2
541 741
9221 9222
CH3 CH4
940 1140
9213 9214
CH3 CH4
941 1141
9223 9224