Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 206

Procedure for using the wave output function
Use the following procedure to use the wave output function.
1.
Register the wave pattern
Page 250 Register the wave pattern
2.
Set the wave output function parameters
Page 254 Setting the wave output function parameters
3.
Save the wave pattern
Page 254 Save the wave pattern
4.
Parameter setting of the analog output module
Page 209 Parameter setting of the analog output module
5.
Transfer the wave output data
Page 212 Transfer the wave output data
6.
Start, stop, or pause the wave output
Page 214 Start, stop, or pause the wave output
Restrictions and precautions on the wave output function
The wave output function has the following restrictions and precautions.
■Output mode setting
To use the wave output function, set the output mode setting to the wave output mode. This makes all channels operate in the
wave output mode.
■Output range setting
No user range is available. When executing the wave output function, be sure to use anything other than the user range.
For output range setting, refer to the following.
Page 185 Range switching function
■Unavailable functions
When the wave output function is selected, the scaling, shift, and rate functions are unavailable. Also, the setting description
of "Disconnection detection auto-clear enable/disable setting" (Un\G304) will be ignored, and the setting will be disable. When
executing the wave output function, be sure to disable them.
■Analog output HOLD/CLEAR function
The analog output HOLD/CLEAR function differs from operation from that for normal output.
For details, refer to the following.
Page 187 In the wave output mode
Setting the wave output function parameters
To use the wave output function, the parameters of the wave output function needs to be set on the "Create Wave Output
Data" window.
Setting item
Output setting during wave output stop
Output value during wave output stop
Wave pattern start address setting
Wave pattern data points setting
Wave pattern output repetition setting
Constant for wave output conversion cycle
For details on the buffer memory areas, refer to the following.
Page 292 Details of buffer memory addresses
2 FX5-4DA
204
2.4 Functions
Reference
Page 254