Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 305

Interrupt factor generation setting [n]
Set an interrupt request for when the same interrupt factor occurs during the interrupt factor detection.
Setting value
0
1
• When 'Interrupt factor generation setting [n]' (Un\G200 to Un\G215) is Interrupt resend request (0) and the same interrupt
factor occurs during the interrupt factor detection, an interrupt request is sent to the CPU module again.
• When 'Interrupt factor generation setting [n]' (Un\G200 to Un\G215) is No interrupt resend request (1) and the same
interrupt factor occurs during the interrupt factor detection, an interrupt request is not sent to the CPU module.
If a value other than the above is set, an interrupt factor generation setting range error (error code: 180H) occurs.
"n" and  indicate an interrupt setting number. (n = 1 to 16,  = 0 to F)
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Interrupt factor generation setting
[n]
Interrupt factor generation setting
[n] (in FX3 allocation mode)
■Enabling the setting
Turn on and off 'Operating condition setting request' (Un\G70, b9) to enable the setting.
■Default value
The default value is Interrupt resend request (0) for all buffer memory areas.
Condition target setting [n]
Set an interrupt factor to be detected.
Setting value
0
1
2
3
4
If a value other than the above is set, a condition target setting range error (error code: 181H) occurs.
Turning off and on 'Error flag', 'Alarm output flag' and 'Disconnection detection flag' set in 'Condition target setting [n]'
(Un\G232 to Un\G247) or turning on and off 'External power supply READY flag' set in 'Condition target setting [n]' (Un\G232
to Un\G247) send an interrupt request for the CPU module.
"n" and  indicate an interrupt setting number. (n = 1 to 16,  = 0 to F)
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Condition target setting [n]
Condition target setting [n] (in
FX3 allocation mode function)
■Enabling the setting
Turn on and off 'Operating condition setting request' (Un\G70, b9) to enable the setting.
■Default value
The default value is Disable (0) for all buffer memory areas.
1 2 3 4 5
200 201 202 203 204
4061 4062 4063 4064 4065
1 2 3 4 5
232 233 234 235 236
4081 4082 4083 4084 4085
Setting content
Interrupt resend request
No interrupt resend request
6 7 8 9 10
205 206 207 208 209
4066 4067 4068 4069 4070
Setting content
Disable
Error flag (Un\G69, b15)
Alert output flag
Disconnection detection flag
External power supply READY flag (Un\G69, b7)
6 7 8 9 10
237 238 239 240 241
4086 4087 4088 4089 4090
11 12 13 14 15
210 211 212 213 214
4071 4072 4073 4074 4075
11 12 13 14 15
242 243 244 245 246
4091 4092 4093 4094 4095
APPX
Appendix 8 Buffer Memory Areas
16
215
4076
A
16
247
4096
303