Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 445

Operation mode monitor
The operation mode status in operation can be checked.
Monitor value
0
1
2
3
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Operation mode monitor
Operation mode monitor (In FX2N allocation mode function)
Input signals
A state of a multiple input module can be checked in the buffer memory area.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Input signals
Input signal (In FX2N allocation mode function)
■List of input signals
Buffer Memory Areas
b0
b1 to 4
b5
b6
b7
b8
b9
b10
b11
b12
b13
b14
b15
■Module READY (b0)
Module READY (b0) turns on to indicate the preparation for the conversion is completed after the power-on or after the reset
of the CPU module, and the conversion is performed.
In the following cases, 'Module READY' turns off.
• In the offset/gain setting mode (In this case, the conversion is performed.)
• When a watchdog timer error has occurred in the multiple input module (In this case, the conversion is not performed.)
Description
Normal mode
Offset/gain setting mode
FX2N Allocation Mode
2CH conversion mode
CH1 CH2 CH3 CH4
60
60
CH1 CH2 CH3 CH4
69
69
Description
Module READY
Use not allowed
Offset/gain initialization completed flag
Disconnection detection signal
Use not allowed
Warning output signal
Operating condition setting completed flag
Offset/gain setting mode status flag
Channel change completed flag
Input signal error detection signal
Use not allowed
Conversion completed flag
Error flag
CH5 CH6 CH7
CH5 CH6 CH7
APPX
Appendix 12 Buffer Memory Areas
CH8
CH8
A
443