Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 300

■Operating condition setting completed flag (b9)
When changing values of the buffer memory, use 'Operating condition setting completed flag' (Un\G69, b9) as an interlock
condition to turn on and off 'Operating condition setting request' (Un\G70, b9).
For the buffer memory addresses which require turning on and off of 'Operating condition setting request' (Un\G70, b9) to
enable the changed values, refer to the following.
Page 281 Buffer Memory Areas
When 'Operating condition setting request' (Un\G70, b9) is on, 'Operating condition setting completed flag' (Un\G69, b9) turns
off.
Module READY
(Un\G69, b0)
Operating condition setting
completed flag (Un\G69, b9)
Operating condition setting
request (Un\G70, b9)
■Offset/gain setting mode status flag (b10)
When registering the value, which has been adjusted with the offset/gain setting, use 'Offset/gain setting mode status flag'
(Un\G69, b10) as an interlock condition to turn on and off 'User range write request' (Un\G70, b10).
Module READY (Un\G69, b0)
Offset/gain setting mode
status flag (Un\G69, b10)
User range writing request
(Un\G70, b10)
■Channel change completed flag (b11)
When changing a channel to perform the offset/gain setting, use 'Channel change completed flag' (Un\G69, b11) as an
interlock condition to turn on and off 'Channel change request' (Un\G70, b11).
Offset/gain setting mode
Offset specification,
Offset/gain setting mode
Gain specification
Channel change completed
flag (Un\G69, b11)
Channel change request
(Un\G70, b11)
APPX
298
Appendix 8 Buffer Memory Areas
Controlled by the analog output module
Controlled by the program
ON
ON
Controlled by the analog output module
Controlled by the program
OFF
ON
Controlled by the analog output module
Controlled by the program
Channel to adjust the offset or channel to adjust the gain
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
OFF