Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 452

Rate alarm change rate selection
Select rate alarm change rate. "Rate specification" that sets the rate alarm upper limit value and the rate alarm lower limit
value in units of 0.1% with respect to (the maximum value of the digital output value) - (the minimum value of the digital output
value), and "Digital output value specification" that sets in units of digits for the range of digital output values, can be selected.
Setting value
0
1
When setting to a value other than the above table, it operates with digital output value specification (1).
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Rate alarm change rate selection
Rate alarm change rate selection (in FX2N allocation mode
function)
■Enabling the setting
Turn offon 'Operating condition setting request' (Un\G70, b9) to enable the setting.
■Default value
Digital output value specification (1) is set.
Input signal error/Disconnection detection automatic clear enable/disable setting
Set whether to enable or disable auto-clear of input signal error or disconnection detection with the input signal error detection
function or disconnection detection function.
Setting value
0
1
Setting a value other than in the table above results in operation with Disable (1).
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Input signal error/Disconnection detection automatic clear
enable/disable setting
Input signal error/disconnection detection auto-clear enable/
disable setting (in FX2N allocation mode function)
■Enabling the setting
Turn offonoff 'Operating condition setting request' (Un\G70, b9) to enable the setting.
■Default value
The default value is Disable (1) for all the channels.
APPX
450
Appendix 12 Buffer Memory Areas
Description
Rate specification
Digital output value specification
CH1 CH2 CH3
299
130
Description
Enable
Disable
CH1 CH2 CH3
304
133
CH4 CH5 CH6
CH4 CH5 CH6
CH7 CH8
CH7 CH8