Part Names - Mitsubishi Electric MELSEC iQ-F FX5 User Manual

Part names

This section describes the part names of the analog output module.
2-4.5 mounting holes
[3]
[2] [4]
[5]
[1]
[9]
No. Name
[1] Terminal block (Spring clamp terminal
block)
[2] Expansion cable
[3] Direct mounting hole
[4] Operations status display LEDs
[5] Extension connector
[6] Name plate
[7] DIN rail mounting groove
[8] DIN rail mounting hook
[9] Pull out tab
LED display
The following table lists the LED display.
LED display LED color
POWER Green
RUN Green
ERROR Red
ALM Red
[6]
Description
For the current/voltage output and the input of 24 V external power supply.
Cable for connecting the module when adding the analog output module.
Screw holes (2-4.5, mounting screw: M4 screw) for direct installation.
Indicates the operating status of the module. (Page 181 LED display)
Connector for connecting the extension cable of an extension module.
The product model name and manufacturer's serial number are shown.
The module can be installed on DIN46277 rail (35 mm wide).
Hook for mounting the module on a DIN rail of DIN46277 (35 mm wide).
They are used when drawing out an extension cable.
Description
Indicates the power supply status.
ON: Power ON
OFF: Power off or module failure
Indicates the operating status.
Light on: Normal operation
Flashing: Offset/gain setting mode
Light off: Error occurring
Indicates the error status.
ON: Minor error
Flashing: Moderate error or major error
OFF: Normal operation
Indicates the alarm status.
ON: Alarm occurred
OFF: Normal operation
[7]
[8]
2
2 FX5-4DA
181
2.2 Specifications