CHAPTER 2
This chapter describes the part names of the head module.
No.
Name
RUN LED
MODE
LED
1)
REM. LED
D LINK
LED
SD LED
RD LED
20
Downloaded from
ManualsNet.com
PART NAMES
1)
2)
3)
Indicates the operating status.
On
Operating normally. (RUN state)
Operating normally. (STOP state)
• The switch of the head module is set to STOP. (Data transfer between the devices in the head module is
stopped.)
Flashing
• The master station is in the STOP state. (Data transfer between the devices in the head module is
continued.)
• Accepting remote STOP request
• The head module has stopped due to an error (except a watchdog timer error).
Off
A hardware failure or a watchdog timer error has occurred.
Indicates the mode.
On
Online mode
Flashing
Test mode
Off
Offline mode
Indicates the operating status of the own station.
On
Operating normally.
The own station has not been reset after writing data to the CPU module. Or, forced input/output is being
Flashing
registered.
Off
The initial data are being processed, or an error has occurred in the own station.
Indicates the data link status.
On
Data link (cyclic transmission being performed)
Flashing
Data link (cyclic transmission stopped)
Off
Data link not in operation (disconnected) or offline mode
Indicates the data sending status.
On
Data being sent
Off
Data not sent
Indicates the data receiving status.
On
Data being received
Off
Data not received
search engine
6)
4)
5)
6)
Description
7)